NEXCOM NEX 852VL2 - Manual (Page 53)

Power-Supply Type
Switch to ATX if it is an ATX power supply type.
Auto Power-Failure Resume
Choose OFF if auto poewr is resumed.
ACPI Function
The ACPI standard (Advanced Configuration and Interface power) allows the operating system directly to
check the functions of energy saving and the PnP (Plug and Play) functionality. The ACPI functions are
normally activated by the BIOS. The choices are: Enabled and Disabled.
Video Off Method
This determines the manner in which the monitor is blanked. There are three choices:
1. V/H SYNC+Blank: This selection will cause the system to turn off the vertical and horizontal
synchronization port and write blanks to the video buffer.
2. Blank Screen: This option only writes blanks to the video buffer.
3. DPMS Support: Select this option if your monitor supports the Display Power Management
signaling (DPMS) standard of the Video Electronics Standard to select video power management
values.
Video Off In Suspend
This determines the manner in which the monitor is blanked. The choices: Yes, No.
MODEM Use IRQ
This determines the IRQ in which the MODEM can use. The choices are 3, 4, 5, 7, 9, 10, 11, and NA
Suspend Mode
After the selected period of system inactivity, all devices except the CPU shut off. The choices are 1~2 min,
2~3 min,…. Up to 1 hour.
HDD Power Down
After the selected period of drive inactivity, the hard disk drive powers down while all other devices remain
active.
Soft-Off by PWR-BTTN
This function can turn the system off with the on/off button places the system in a very low-power-usage
state, with only enough circuitry receiving power to detect power button activity or Resume by Ring activity.
The choices are Delay 4 seconds, and Instant-Off.
52