NEXCOM NEX 852VL2 - Manual (Page 42)

Floppy 3 Mode Support
Floppy 3 mode refers to 3.5” diskette with a capacity of 1.2MB. This mode is sometimes used in Japan.
Video
Set this field to the type of graphics card installed in your system. If you are using a BGA or higher
resolution card, choose the EGA/VGA option. The options are:
Š
EGA/VGA Enhanced Graphics Adapter/Video Graphics Array. For EGA, VGA, SEGA or PGA
monitor adapters
Š
CGA40 Color Graphics Adapter, power up in 40 column mode
Š
CGA80 Color Graphics Adapter, power up in 80 column mode
Š
MONO Monochrome adapter, includes high resolution monochrome adapters
Halt On
During the Power-On Self-Test (POST), the computer stops if the BIOS detect a hardware error. This setting
determines which type of error will cause the system to halt during boot. The options are:
a hard disk, change the value to Manual and then manually configure the drive by entering the characteristics
of the drive in the items below:
Š
Capacity Approximate hard disk drive capacity
Š
Cylinder Number of cylinders
Š
Head Number of heads
Š
Precomp Write pre-compensation cylinder
Š
Landing Zone Landing zone
Š
Sector Number of sector
Refer to your drive’s documentation or look on the drive if you need to obtain this information. If no device is
installed, change the value to None.
Drive A
Select this field to the type of floppy disk drive installed in your system. The choices are:
Š
None No floppy drive installed
Š
360K, 5.25 in 5-1/4 inch PC type standard drive; 360 kilobyte capacity
Š
1. 2M, 5.25 in 5-1/4 inch AT-type high-density drive; 1.2 megabyte capacity
Š
720K, 3.5 in 3-1/2 inch double-sided drive; 720 kilobyte capacity
Š
1.44M, 3.5 in 3-1/2 inch double-sided drive; 1.44 megabyte capacity
Š
2. 88M, 3.5 in 3-1/2 inch double-sided drive; 2.88 megabyte capacity
Note: The None option could be used for diskless workstations.
41