Monroe Electronics Charge Plate - Monitor - model 288B - Manual (Page 17)

17
ADDITIONAL FEATURES
:
Group and Location –
By accessing this screen the tests can be organized to reflect the ionizers’ locations. There
are up to 17 Groups available, with a maximum of almost 700 locations. The total number
of group/locations available will vary depending on how extensive the tests are for the
individual locations (i.e. how many decays are run for each ionizer). Up to 1500 tests may
be run. By using a PC connected to the units RS232 port it is possible to custom label these
group/locations (i.e. Building 10 - Bench 2E). Via the same link it is then possible to
download all the test results stored in the unit into a spreadsheet on the PC.
Figure 18. Select Group/Location for the test
NEXT: to highlight the next Group.
NXTLOC: Select the same group, next location from the current one.
CANCEL: Cancel the selection.
SELECT: Select the highlighted group. This will lead to select location screen.
Test Parameter Setups –
In both the Manual and Automatic Modes there are five distinct setups. Three of these are
available to the user to customize as needed. The other two are the factory and test
settings, which are not adjustable. Any of these can be selected as the default test setup.
Data Storage and Review –
All test results are stored in the internal memory of the unit. They can be viewed through
the screen or downloaded to a PC. Each test records the time, date, temperature, humidity
and test results.
GRP/LOC Default Grp/Loc Name
Grp# Name #ofLoc AMTest
Current:
1 Group A 99 00
Group A 2 Group B 99 00
Location 1 3 Group C 99 00
MaxGrp 17 4 Group D 99 00
NEXT NXTLOC CANCEL SELECT
Group A has 99 locations.
AMTest: A(uto sequence) /
M(annual) test Setup for
this Group:
0=Use Default setup
1=Use A/M Setup 1;
2=Use A/M Setup 2;
3=Use A/M Setup 3;
4=Factory
5=Test
AMTest can be set in the
PC software when entering
the Group/locations..