Monroe Electronics Charge Plate - Monitor - model 288B - Manual (Page 15)

15
When the auto sequence tests are finished, data will be shown as follows:
Figure 16. Auto Sequence Test Review:
NxtCyc: highlight the next
data row.
MAIN: back to MAIN screen.
AUTO: start another auto
sequence test.
Programming features for Auto Sequence Test:
Start voltage – Same as manual
Charge Differential – Same as manual
Stop voltage – Same as manual
Test Start Delay – Same as manual
Max Decay Time – Same as manual
Balance Duration – Same as manual
Decay Cycle – Range from 1 to 10, adjustable in increments of 1. This is the number of 
and – decays the unit will run in an automatic sequence.
Decay Sequence – Select either the decay sequence of     or     for the number of
cycles selected in Decay Cycle.
Cycle Delay – Range from 2sec to 15sec, adjustable in 1sec increments. This is the
amount of time from the finish of the last decay cycle to the start of the next.
Balance (Y/N) – Select whether or not you want a balance test to automatically run at the
end of the decay cycle.
Continuous – This feature allows you to perform a continuous series of tests on a
selectable time basis. For example, you want to run a series of decay and balance every
hour for the next day. From the automatic screen select CONT, then select the desired test
time interval from 1 minute to 24 hours. Once you have programmed the time, press EXIT
and you will advance to the next screen. From this screen you have the option of pressing
CANCEL or START. The START key begins the default automatic test sequence and will
repeat that test sequence at the time interval selected. This continuous testing will continue
until you stop the tests or the memory becomes full.
Group A
Location 2
06/22/08
03:32:56P
30C 62%RH Av 6.5s 6.5s
+Vp=+22.6 –Vp=-12.3 Vav=+04.5
NxtCyc MAIN AUTO 3 +Decay EndV -Decay EndV
1 6.5s 6.5s .
2 6.5s 6.5s
3 6.4s 6.5s