KLING & FREITAG K&F SEQUENZA 10 W - Manual (Page 31)

User's manual K&F SEQUENZA 10 N/W/B & Flying Frame
KLING & FREITAG GMBH © 2014 Version Version 6.1 Page 31 of 70
5.
Position each spring bolt
horizontally when the
corresponding speakers touch each
other during lifting.
The spring bolts do not snap into place until the speaker enclosures begin to move apart
again and the preselected angle position is reached. It is possible that this will happen
when the array is relatively high.
6.
Warning
Check that the spring bolts
protrude at least 0.5 mm out
of the drill holes at the entire
circumference (A).
7. When the first speakers are at working height, remove the front transport covers.
8. When the first SEQUENZA 10 N/W speakers are at working height, you can attach the
protective weather covers for this speaker model, if necessary.
For outside uses, these optional protective weather covers with hook-and-loop fastener
serve as rain protection for the rear flying mechanics and the cable connections.
9. Lift the array evenly and slowly into its operating position so that it cannot swing out
during lifting, then secure it. In doing this, make sure that chain hoists and lifting
accessories do not get caught. Make sure that the speaker cables do not get crimped or
get caught.