KLING & FREITAG K&F SEQUENZA 10 W - Manual (Page 27)

User's manual K&F SEQUENZA 10 N/W/B & Flying Frame
KLING & FREITAG GMBH © 2014 Version Version 6.1 Page 27 of 70
10.1.3 Array with SEQUENZA 10 N/W and SEQUENZA 10 B
1. Create an array with SEQUENZA 10 N/W, see chapter Array with SEQUENZA 10 N/W as
of page 20.
2. Create an array with SEQUENZA 10 B, see chapter Array with SEQUENZA 10 B as of
page 24.
3.
Remove the 4 Quick Release Pins
(A) on the flying frame of the
SEQUENZA 10 N/W array and turn
out the 4 angled joint plates (B), as
illustrated.
Secure the angled joint plate (B)
with the Quick Release Pin (A) in
this position.
Proceed accordingly with the 3
remaining angled joint plates of the
flying frame.
4.
Push the SEQUENZA 10 N/W array
and the SEQUENZA 10 B array
together so that all 4 angled joint
plates of the flying frame protrude
into the connecting brackets of the
lower SEQUENZA 10 B system.
5.
Secure all 4 angled joint plates with
the remaining Quick Release Pins
on the bottom SEQUENZA 10 B
system.