KLING & FREITAG K&F SEQUENZA 10 W - Manual (Page 20)

User's manual K&F SEQUENZA 10 N/W/B & Flying Frame
KLING & FREITAG GMBH © 2014 Version Version 6.1 Page 20 of 70
10. Flown Setup
10.1 Combining the Speaker Array
10.1.1 Array with SEQUENZA 10 N/W
The splay angles of the individual speakers are determined by the simulation software
CON:SEQUENZA. CON:SEQUENZAYou will find the specifications on the relevant calculation
printouts. On the rear joint plate of the speakers, there are drill holes with the corresponding
angles marked.
Warning
Control the secure fit of every ball lock pin during setup.
1.
Slide the front joint plates out of
the speaker by reaching into the
access opening (A) and pushing the
joint plate forwards.
Secure the joint plates(B) with the
Quick Release Pins(C).
2.
Slide the speakers together so that
the joint plates protrude into the
front connecting bracket.