ILUMINARC Ilumipod™ Inground Tri-12 IP - Manual (Page 6)

Introduction
2 Ilumipod Inground IP Series User Manual (Rev. 4)
There are no
user serviceable
parts inside this
product. Any reference to
servicing it you may find
from now on in this User
Manual will only apply to
properly ILUMINARC
®
authorized technicians.
Do not open the housing
or attempt any repairs
unless you are certified to
do so.
Please refer to all
applicable local
codes and
regulations for the proper
installation of this product.
Keep this manual
for future
consultation. If
you sell this product to
another user, make sure
that they also receive this
manual.
In the unlikely
event that your
Ilumipod
Inground IP product may
require service, please
contact ILUMINARC
®
Technical Support.
Safety Notes
Please read all the following safety notes carefully because they include important information
on how to install, use, and maintain this product safely.
Personal Safety
· Avoid direct eye exposure to the light source while the product is on.
· Always disconnect the Ilumipod Inground IP product from its power source before
servicing.
· CAUTION: When transferring product from extreme temperature environments, (e.g.
cold truck to warm humid ballroom) condensation may form on the internal electronics
of the product. To avoid causing a failure, allow product to fully acclimate to the
surrounding environment before connecting it to power.
· Always connect the Ilumipod Inground IP product to a grounded circuit to avoid the risk
of electrocution.
Mounting and Installation
· The Ilumipod Inground IP products are for outdoor use and they can work while
submerged in up to 1 m of water (IP67). However, do not submerge it deeper than 1m
for more than (30) thirty minutes.
· Observe the installation instructions regarding drainage to ensure that the water level is
never higher than 1 m for more than (30) thirty minutes to comply with the IP67 rating.
Power and Wiring
· Always make sure that you are connecting this product to the proper voltage, as per the
specifications in this manual or on the product’s sticker.
· Never connect this product to a dimmer pack.
· Make sure that the power cable is not cracked, crimped, or damaged.
· Make sure that the sealed cover is properly adjusted to avoid water entering the unit.
Operation
· The maximum ambient temperature (Ta) is 113 °F (45 °C). Do not operate this product
at a higher temperature.
· In case of a serious operating problem, stop using this product immediately!