ILUMINARC Ilumipod™ Inground Tri-12 IP - Manual (Page 17)

Operation
Ilumipod Inground IP Series User Manual (Rev. 4) 13
Make sure to
press
after selecting an
option. Otherwise, the
product will not save the
new setting. In this case,
the Ilumicode’s display
will show “SEND…”
The DMX Starting
Address setting
works with all but
the REMOTE
personality.
Programming
Carry out all the programming procedures indicated below from Ilumicode’s panel. Refer to the
corresponding Menu Map (pages 11 and 12) to learn how the menu options relate to each other
depending on the type of product.
Use and
Press to accept the selected value for an option. This will send that value to the
product(s).
DMX Personality
(All Ilumipod Inground IP products)
1. Go to PERSON and select any DMX personality that matches the product with which
you are working (ignore any other options).
36 IP RGB & Tri-12 IP 36 IP VW
ARC1
ARC+D
ARC FULL
SOLID SOLID
SPECIAL1
VW
VW+D
2. Make sure to arrange the DMX addresses of all products in the current DMX universe
to avoid address overlapping.
DMX Starting Address
(All Ilumipod Inground IP products)
1. Go to DMX.
2. Select a starting DMX address (001~512).
Dimmer
(All Ilumipod Inground IP products)
1. Go to DIMMER.
2. Select a dimmer curve (OFF or DIM1~4).
DIMMER Description
OFF Dimmer curve is linear with fader
DIM1 Non-linear (fastest)
DIM2 Non-linear (fast)
DIM3 Non-linear (slow)
DIM4 Non-linear (slowest)