ILUMINARC LΩGIC™ 1X36 - Manual (Page 15)

Operation
L
ΩGIC™ 1X36 User Manual Rev. 08
11
4. Operation
When running
the product
using a DMX
controller, make sure that
the Menu>Run is set to
DMX.
Control Panel Description
Button Function
Exits from the current menu or function
Enables the currently displayed menu or sets the currently selected value in
to the current function
Navigates upwards through the menu list and increases the numeric value
when in a function
Navigates downwards through the menu list and decreases the numeric
value when in a function
Control Options
You can set the
LΩGIC™ 1X36 start address in the 001~512 DMX range. This allows for the
control of up to 64 products in the 8-channel EFFECT personality.
Programming (RGB Mode)
Refer to the Menu Options section on page 18 to learn how the menu options relate to each
other. The Menu Options section has a Main level and a variable number of programming
levels for each option.
To go to an option in the Main level, press
To select an option or value within the current programming level press or
until it shows on the display. Press to accept it. In this case, if there is another
programming level, you will see its first option. Otherwise, you will see the selected value.
To exit to the previous menu level, press
Mode Selection
1. Go to MENU>SET.
2. Select GO RGB?
3. Select YES?
DMX Addressing
1. Go to MENU>DMX.
2. Select the starting address [001~512].
3. Go to MENU >RUN.
4. Select DMX.
DMX Personality
1. Go to MENU>PERSON and select any DMX personality.
2. Make sure to rearrange the DMX addresses of all products in the current DMX
universe to avoid address overlapping.