DT Videolabs PlaybackPro Plus - Manual (Page 8)

PlaybackPro Plus User Guide
Page 7
(1) Take Duration - Controls how the Preview clip transitions to Program when Take
is clicked. A negative number creates a Dissolve (-3.00 = 3 second dissolve), zero
creates a Cut, and a positive number creates a Delay (+3.00 = 3 second Delay).
(2) Fade On Take Duration - If Take is clicked while a clip is playing in Program,
and the Link Duration is +0.00 or greater (a Cut or Delay), this control fades Program
video and audio for the designated duration, before performing the Cut or Delay.
(3) Take - Takes Preview clip to Program. When a clip is already playing in Program,
Take Duration determines how it is transitioned (i.e. Dissolve, Cut or Delay).
If there is nothing playing in Program, clicking Take causes the Preview clip to begin
playing immediately (as a Cut), regardless of the Link Duration.
(1) Take
Duration
(2) Fade On
Take
Duration
On Take (3) Image
No Program Playing
N/A N/A When Program is not playing, Preview will Cut to Program.
Mixing Preview and Program Clips
-x.00 N/A Preview will Mix to Program for x seconds.
Cutting Preview and Program Clips
+0.00 +0.00 Preview will Cut to Program.
+0.00 +y.00 Preview will Cut to Program after Program fades for y seconds.
Delay between Preview and Program Clips
+x.00 +0.00 Preview will Cut to Program after Delay of x seconds.
+2.00 +2.00 Preview will Cut to Program x seconds after Program fades for y seconds.
Blank Not Applicable Legend:
Take:
1
2
3
1 2 3
Possible Take Transitions: