DT Videolabs PlaybackPro Plus - Manual (Page 7)

PlaybackPro Plus User Guide
Page 6
Navigation Controls:
These are used for finding specific parts of a clip to set In, Out and Slate points.
There is a set of controls for both Preview and Program.
Show Controls:
(1) Goto In / Out - Moves the playback position to the In or Out Point.
(2) Control Buttons - Fast Reverse, Play-Pause Toggle, Pause, Play and Fast Forward
buttons (in order).
(3) Shuttle - Temporarily changes the playback speed. Primarily used to set up a clip
in Preview, however it can be used in Program. Clips in Program always begin
playback at normal speed.
(4) Scrubber - Used to find specific parts of a clip so that In, Out, and Slates can be
set. Primarily used in Preview, however can be used while in Program. When a
Preview clip is Taken to Program, it starts from its In Point regardless of the Scrubber
Position.
1
2
3
4
Take Program’s End Kill
The Show Controls breakdown into 3 areas: Take, Program’s End and Kill. Each is
covered in the following sections.