DT Videolabs PlaybackPro Plus - Manual (Page 17)

PlaybackPro Plus User Guide
Page 16
UDP and TCP Basics
To control PlaybackPro Plus from a device other
than SimpleSync, use UDP or TCP IP control.
Select UDP Listen or TCP Listen from the
Connection popup menu in the Network Setup
sheet. To stop all communications, select No
Control from the Connection popup menu.
PlaybackPro Plus listens for a connection on port
4647. Set the IP address (should be static) and
port number on the device that will be controlling
PlaybackPro Plus, and tell it to connect. Once
connected, the Network Status will show TCP/IP
Connected, rather than TCP/IP Listening.
Disconnect the remote source before selecting a
different remote option. See The PlaybackPro Plus Protocol (UDP / TCP) section
for commands.
PlaybackPro Plus listens for commands on port 7000.
Set the IP address (should be static) and port number
on the device that will be controlling PlaybackPro
Plus. UDP is a connection-free protocol. See The
PlaybackPro Plus Protocol (UDP / TCP) section for
commands.
UDP
TCP