Doremi Nugget - Manual (Page 38)

5.2 Synchronizing Nugget Units using Chase
To Synchronize 2 Nugget Units:
• Designate one unit as Master and the other as Slave.
• Connect the LTC Out from the Master to the LTC IN of the slave
• Feed external video sync to both units
• Set the SYNC SRC on both units to SYNC IN
• Set the CHASE MODE on the Master to OFF
• Set the CHASE MODE on the slave to ON
• Set the Chase mode DRIFT to 0 except for 720p formats where the DRIFT must be set
to at least 2.
If you control the Master unit and start playing, the Slave will follow based on the LTC
connection between Master and Slave.
5.3 Synchronizing 2 Nugget Units Automatically
If you want to setup the Nugget units to start synchronous playback at power up:
• Designate one unit as Master and the other as Slave
• Connect the LTC Out from the Master to the LTC IN of the slave
• Feed external video sync to both units
• Set the SYNC SRC on all units to SYNC IN
• Set the CHASE MODE on the Master to OFF
• Set the CHASE MODE on the slave to ON
• Set the LOOP MODE on the Master to ON
• Set the LOOP MODE on the slave to ON
• Set the AUTO START on the Master to File, select the filename and set auto start to
Play
• Set the AUTO start on the Slave to File, select the filename and set auto start to Pause
• Save Defaults on both Master and slave.
If you reboot both units, the Master will load the designated file automatically and starts
playback. The slave will also load the designated file automatically and because Chase is ON
on the slave, it will start reading LTC from the Master and follow. Since LOOP MODE is ON,
both Master and slave will keep on looping for continuous playback.
NUG.OM.000105.DRM Page 38 Version 3.1
Doremi Labs, Inc.