Doremi Fidelio - Manual (Page 29)

FDO.OM.001852.DRM Page 29 of 77 Version 1.5
Doremi Labs
3.2.1.2 CaptiView
 If the auditorium you’re installing the Fidelio audio distribution system into has a
CaptiView transmitter installed, you can plug the CaptiView transmitter into the port
labeled “CaptiView” on the front of the Fidelio Transmitter box.
Note: The Fidelio Transmitter box must be connected to the Doremi Digital Cinema Server via a
USB cable for the CaptiView transmitter to transmit the CC (Closed Captioned) information to
the CaptiView Display(s) in the auditorium. The CaptiView transmitter shall at least be 20cm
away from the Fidelio transmitter antenna
– usage of a USB extension cable will be needed for
the CaptiView transmitter connection.
3.3 Fidelio Audio Interface Connections
 The Fidelio Audio Interface box has the ability to interface with both the DB25 connector
and RJ-45 connectors. In either case, the Fidelio Audio Interface box is used to access
the AES audio channels, 15/16 & 7/8, to then transmit to the Fidelio Receiver.
3.3.1 Server to Audio Interface and then to Theater Sound Processor
3.3.1.1 DB25 Connector Setup

If your setup consists of using the DB25 cable, you will need to disconnect the DB25
cable from your Doremi digital cinema server and connect this cable to the connector on
the Fidelio Audio Interface Box labeled, AES THRU CH 1-6, CH 9-14 (Figure 32).

The other end on this cable is to remain connected to your audio processor.
 Using the short DB25 cable provided, connect one end into the AES OUT on the Doremi
server and the other end into the AES IN connector on the Fidelio Audio Interface box.
Figure 32: Audio Interface for DB25 Setups