Datamax S-Class ST-3210 - Manual (Page 56)

46 ST/SV-3210 and ST/SV-3306
Print Engine (continued)
Maximum Fields and
Characters Per Ticket:
600 fields with 16,000 characters per ticket
Tear Bar: Tear up/down
DRAM Memory:
Internal Module Size:
Scalable Module Size:
4 MB
512 KB (default)
256 KB (default)
EPROM Memory: 1 MB
Ticket Stock Requirements
Type: Fan-fold and roll (if option equipped)
reflective
[1]
direct thermal stock.
Maximum Ticket Width: 3.25 inches (82.55 mm)
Minimum Ticket Width: 1.9 inches (48.2 mm)
Ticket Thickness Range:
(if Cutter option equipped): .005 inch – .010 inch (.13 mm – .25 mm)
.025 inch – .008 inch (.06 mm – .2 mm)
Fanfold Ticket Length
(ST models only):
11.375 inches (289 mm) maximum for interior
placement of the stock.
Fanfold Ticket Height
(ST models only):
4.5 inches (114.3 mm) maximum for interior
placement of the stock.
Roll Capacity
(if Roll Hanger option
equipped):
7.0-inch (177.8 mm) maximum outer diameter
rolls of ticket stock wound with the TOF Marks
facing inward, on 2.0-inch (50.8 mm) diameter
cores.
[1]
The reflective TOF Mark must be black, carbon based, and placed on the backside of
the stock with a minimum size of .125 inch (3.175 mm) long (direction of travel) by
.5 inch (12.7 mm) wide, with the center falling between .235 inch (6 mm) and 3.03
inches (77 mm) from the edge while allowing adequate Quiet Zone space (see the
diagram in Section 6.1). The reflectance of the mark shall be less than 10% at
wavelengths of 950 and 640 nm.