Dataman S4 - Manual (Page 55)

DATAMAN S4 MANUAL
BURN KEY 55
BURN KEY
BURN (START)-(END) = (DEST)
See Glossary for the special ways of editing
the parameter line.
BURN programs a PROM in the ZIF with the
contents of the USER-RAM between the
START and END addresses.
If S4 powers down during BURN, because lack
of battery-power is sensed, the PROM will still
be programmed correctly up to the point where
the program aborted.
S4 must be configured for the right PROM. A
warning message gives the PROM type, the
program voltage and the pin to which it is
applied. If these are wrong, the PROM could
be destroyed. Note that pin number refers to
the PROM. In the case of 24 or 28 pin PROMS
the pin number will be different from the pin
number of the 32 pin socket.
If the ESCape key is pressed whilst editing the
parameters or even after the programming
starts, the process is aborted at that point. To