Dataman S4 - Manual (Page 52)

DATAMAN S4 MANUAL
52 SEEK KEY
SEEK KEY
Searches through a block of code from
(START) to (END) for a sequence of up to six
bytes. Bytes are pairs of hex characters, or
"wild" characters, which can have any value.
Wild characters are entered by pressing the
SEEK key again (or terminal X key); they are
represented by X in the seek line. Wild
characters may be used freely for half bytes or
full bytes. The first address which contains
matching data is shown in the display. Press
ENTER to proceed to the next occurrence. Use
ESCape to terminate SEEK. The EDIT key
puts you in the editor at the found address, if
working from the keypad. In any case, SEEK
leaves the last matching address as the EDIT
parameter, so you can EDIT the found data.