CUE controlCUE - Manual (Page 14)

14
controlCUE Controllers | Connecting
© CUE, a.s. | All Rights Reserved.
Bi-directional Serial RS-232/422/485
Overview
These bi-directional serial channels are used for RS-232, RS-422 and RS-485 communication. Maximum
speed is 115 200 Bd (bps). Default mode for all channels is RS-232, other modes must be set in
programming application. For more details see programming manuals.
RS-232 Mode
Output signal levels for RS-232 are in the -10 V to +10 V range. This is default mode for all channels.
SERIAL RS-232
5-pin 3.5 mm Pin Signal Description Direction
1 2 3 4 5
1 TxD RS-232 Transmitted Data From controller
2 RTS RS-232 Request to Send From controller
3 GND Ground
4 RxD RS-232 Received Data To controller
5 CTS RS-232 Clear to Send To controller
RS-422 Mode
This mode must be set in the programming application.
SERIAL RS-422
5-pin 3.5 mm Pin Signal Description Direction
1 2 3 4 5
1 Tx A+ RS-422 Transmit Data (Idles High) From controller
2 Tx B- RS-422 Transmit Data (Idles Low) From controller
3 GND Ground
4 Rx A+ RS-422 Receive Data (Idles High) To controller
5 Rx B- RS-422 Receive Data (Idles Low) To controller
RS-485 Mode
This mode must be set in the programming application.
SERIAL RS-485
5-pin 3.5 mm Pin Signal Description
1 2 3 4 5
1 A+ RS-485 Data +
2 B- RS-485 Data -
3 GND Ground
4 N.C. Not Connected
5 N.C. Not Connected