Ir capture – CUE Wireless Touch Panel User Manual

Page 18

Text mode
Original mode

Wireless Touch Panel | User Manual | IR Capture

IR Capture

All models of cuenium

touch panels have possibility to capture IR codes. This is the same functionality as

some ipCUE controllers have. Captured IR codes can be used in all types of controllers and interfaces capable

to send IR codes.

Steps are as follows

1. Connect the touch panel to your PC as described in the chapter Setup / PC Connection.
2. Arrange IR remoter and touch panel as described below.

IR remoter

3. Start Cue Visual Composer and capture IR codes by standard way.
4. Push Start Capture button in Cue Visual Composer and then press appropriate button on IR remoter

5. Instructions and messages are displayed on the touch panel and in the Cue Visual Composer.
6. If message “Signal is too weak“ is displayed, change position of IR remoter and try again.