CUE irCUE - Manual (Page 8)

User Manual irCUE
www.cuesystem.com
Page 8 of 20
5. Button Labels
irCUE uses the separate plastic upper part of the front panel for customized engraved labels for 11
buttons.
Steps
1. Have the labels engraved on the rear surface of the plastic upper part of the front panel.
Labels must be engraved specularly. Recommended fonts are Nimbus, Trebuchet, Verdana or
Arial, size 6 points, bold.
Label 1 Label 2 Label 3
Label 4 Label 5 Label 6
Label 7 Label 8 Label 9
Label 10 Label 11
Matt front surface Glossy rear surface
Transparent organic glass Engravable layer
2. Clean and degrease the rear glossy part of engraved front panel by denatured alcohol.
Volume Channel
Fn 0 Enter
7 8 9
4 5 6
1 2 3
Release liner
3. Remove the release liner from top part of irCUE.
4. Place the engraved front panel to the upper part of irCUE, Make sure, that the buttons can be
pressed easily and then press the panel to stick together with the irCUE. Be as precise as
possible, because it very difficult to remove the panel once it has been glued.