CUE irCUE User Manual
Page 10
User Manual irCUE
www.cuesystem.com
Page 10 of 20
The ADDRESS of the panel can be set in the range 0 to 47. Default panel ADDRESS is 0, addresses
1 to 47 can be set up by the following procedure:
1. Undo four screws on the rear panel of irCUE and remove the rear cover plate.
2. Press the address button on the PCB. The backlight of irCUE is switched on now and Fn
LED is flashing.
3. Type a 2-digit address using the number buttons on the front side of irCUE (for example
for ADDRESS 0 press buttons 0 and 1) and then press ENTER.
4. If the address has been set correctly, all LEDs are switched off now.
5. If the address has not been set correctly, the color LED around navigation cross will start
flashing. In this case address has not been modified. Start again from point 2.
6. Mount back the rear cover plate of irCUE.
In the table below there are BUTTON_ID ranges for all addresses.
ADDRESS
BUTTON_ID range
0
1001
1064
1
1065
1128
2
1129
1192
3
1193
1256
4
1257
1320
5
1321
1384
6
1385
1448
---
---
---
46
3945
4008
47
4009
4072