2 connecting toughtech to a computer – CRU ToughTech Secure 128 Q User Manual
Page 5
CRU
U s e r M a n u a l f o r T T - Q , T T S - Q ( A 9 - 0 0 0 - 0 0 0 1 r e v 1 . 5 )
- 5 -
NOTE: Most computers do not have a built-in eSATA
connection. If you wish to connect this way, you may
need to install an expansion card inside your computer
to add eSATA connectivity. Such cards are sold by
WiebeTech and other dealers of computer hardware.
2.1.7
Align the edges of the hard drive platform with the internal rails of the outer housing, and carefully
slide the platform into the enclosure.
2.1.8
Fasten the rear panel to the enclosure housing by replacing the screws removed in step 1.
ToughTech is now assembled and ready for connection to a computer.
2.2 Connecting ToughTech to a computer
2.2.1
Connect the USB, FireWire, or eSATA
connector into the corresponding port on
ToughTech.
2.2.2
Connect the AC power adapter to the rear
of ToughTech. Plug the other end into a
grounded electrical outlet.
2.2.3
Plug the other end of the data cable to an available port on your
computer. Turn on the power switch; ensure that the green power LED
indicator is active. The power LED will blink whenever the drive is accessed.