CRU RTX410-IR - Manual (Page 3)

CRU
R T X - I R Q u i c k S t a r t G u i d e A 9 - 4 6 8 - 0 0 0 5 - 1 R E V 1 . 0 - 3 -
NOTE: If any of the drives are inaccessible after
powering on the unit, try the following steps:
1. Turn off the power.
2. Remove the drive(s) in question.
3. Reinsert the drive(s).
4. Turn on the power.
Not sure what type of network you
have? If the IP address displayed on the
LCD starts with 169.254 this indicates
that the network is probably not DHCP-
enabled. Use the instructions for a static
network.
2.2 Check the accessories with your RTX-IR. Please contact CRU if any parts are missing or
damaged. The box should contain the following items:
2.3 Hard Drive Installation
a) Pull the ejection handle on the TrayFree
bay to open the bay door.
b) Insert a bare SATA hard drive into the bay.
Make sure it is label-side up with the SATA
connection on the drive inserted first.
c) Shut the bay door.
d) You can optionally secure each bay door. Doing so is not necessary to operate RTX.
•
For RTX410 and RTX610, Insert an RTX Key into its key lock and turn it 90 degrees clockwise.
• For RTX801-IR, use the Lock Tool to slide the lock to the “locked” position.
3. Setting up Your RTX
The steps below explain how to get your RTX ready to use. If you purchased your RTX pre-configured,
you may skip step 3.
3.1 Connecting RTX to your network (or computer) for configuration.
a) Plug an ethernet cable into the “Config GUI” port on the rear of RTX.
b) Connect the other end of the ethernet cable to your network. Usually, this means plugging it
into a router or hub. In an office environment, you may have a network jack built into your office
wall. If a network connection is not available, you can connect the ethernet cable directly to an RJ45
(ethernet) port on your computer.
c) Connect the power cable to the rear of the RTX and to a grounded electrical outlet.
d) Turn on the RTX unit’s power using the switch on the rear panel.
3.2 Using a web browser to access the GUI (Graphical User Interface).
RTX410-IR & RTX610-IR
Accessories Quantity
Ethernet Cables 2
Power Cable 1
Packet of Keys 1
Manual and Warranty Info 1
RTX801-IR
Accessories Quantity
Ethernet Cables 2
Power Cable 1
Packets of Loc k Tools 1
Manual and Warranty Info 1