Crompton Controls DCM - Manual (Page 11)

10 Getting Started Emotron AB 01-2120-01r2
Fig. 1 Pump operation
If the Emotron DCM has been used previously, some parameters may have been
changed. In such a case, go to Chapter 6 and perform a complete setup for
single-pump system installation (alternatively, Chapter 7 for dual-pump system
installation).
On the following pages is a description for the single-pump setup in general. In
the event of an alarm during setup, see Chapters 8 and 9. For dual-pump setup,
see Chapter 7, Dual-Pump System Installation.
Power pump motor
Set power level
Normal pump load power
Stop level
Pump begins to
draw air (snore)
Time