CIRCUTOR CVM144 Series User Manual

Page 34

Text mode
Original mode

----- Supply network analyzer CVM-144 ------ User's manual --- Page No. 33

- For accessing to the next option, press "

": set-up options for the second

relay will appear.

OUT 2

RELAY 2

CODE

Parameter value (2)

Act as before. Pressing again "

" the set-up mode is exited.

b.- ALARM conditions (1 condition for each relay): If any other parameter (excepts
for energies) is selected at (1), two outputs can be configured as alarms. For each
output it is possible to set:

Any of the parameters measured by the CVM-144
MAXIMUM value
MINIMUM value
Delay for the conditions

These screens are successively displayed by the CVM-144 once the

parameter has been selected ( for the set-up of each option proceed as in the
Section a.-):

b.1.- Programming the maximum value to be controlled:

OUT 1

RELAY 1

AL hI

0.000

Maximum value

The key "max" will increase the value of the blinking digit (0,1...9, sign -- ).

Use the key "min" to pass to the following digit.