Channel Master DVR+ (7500GB16) - Manual (Page 17)

11 Getting Started ::
Programming your remote using Easy Scan
Turn on your TV.
Point the DVR+ remote control at the TV.
Press and hold down both CH+ and VOL- on
the remote simultaneously for at least two
seconds. The blue TV button LED gives two
slow flashes to indicate successful entry into
setup mode.
Press INPUT. The TV button LED comes on.
Press TV POWER repeatedly until the TV
switches off.
Press INPUT. The TV button LED gives two
slow flashes to indicate that the code has been
stored successfully.
1
3
4
5
2
Turn on your TV. Hold down CH + and
VOL - on DVR+ remote
for 2 sec until TV
button flashes twice.
Press the INPUT
button.
Press INPUT . TV
button flashes twice. Press the TV
Power button
until TV is off.