Channel Master DVR+ (7500GB16) - Manual (Page 16)

10 :: Getting Started
Turning on your new DVR+ receiver
When you switch on your DVR+ receiver for the first time, it
may take a minute for two for the unit to power up and display
the Setup Wizard. This will guide you through the steps to set
up your receiver and scan for subscription-free, over-the-air
channels.
Programming the DVR+ remote control
The remote is capable of controlling basic functions of most TVs
(volume up/down, mute/unmute TV sound, TV power on/off, and
change current input). To program the remote control to operate
your TV, you may use either of the following methods:
• Easy Scan as described on the following page.
• Code Entry as described on pages 12-15.
Getting Started
Highlight and
select your
Language &
Country. Press
OK to continue.
Validate connections
are hooked up correctly
and then press
OK to
continue.
A Channel Scan will
begin automatically.
After it is complete, the
next Step is displayed.
Online channels from
your Internet connection
are listed. Press
OK to continue.
Highlight and
select your Zip
Code, Time
Zone & Setting.
Press
OK to
finish setup.
If some channels are
duplicated/unacceptable
In some areas with multiple
transmitters nearby, there
may be duplicate channels.
If there are duplicate over-
the-air channels in your
local area, they will be listed
in the channel 100-199
range in the guide.
If a channel’s transmission
is marginal (for example,
macroblocking or audio
issues) and cannot be
improved (see page 20),
then you may consider
deleting it (see page 28).