Casella CEL CEL-281 - Manual (Page 120)

Paper end: Valid,
Auto linefeed: Off (The dosimeter sends a linefeed),
Skip over
perforation: Invalid,
SLCT IN Internally fixed,
Printer mode Centronics.
6.3 Performing a Printer Download
If OSHA or DOD reports will be required, MAKE SURE that A-weighting
and Slow time-weighting are set before data logging is initiated.
Caution !
When the dosimeter contains stored data that
is to be downloaded to a printer, DO NOT start
or restart logging before downloading.
If logging is started using the key, (or
restarted after it has been stopped by the
+ key combination), the memory is
cleared and ALL stored data lost.
To download the dosimeter store to a printer, with the keypad installed,
proceed as follows.
1. Either: If the dosimeter is switched OFF, go to step 2.
Or: If the dosimeter is switched ON, go to step 4.
2. Switch the instrument ON and wait for the 20 second calibration
delay to expire, (shown when TC =
, , or is displayed.
3. Press the key to leave the calibration mode, then go to
step 5.
Printing Hard Copy Reports
CEL-281 Operator's Handbook - Page 111