Sinking output – Applied Motion BLuDC4-Si User Manual

Page 17

BLuDC-Si Hardware manual

they can be used as general purpose outputs and controlled by

Set Output instructions. The Si

Programmer’s Configure IO dialog allows you to choose the function of each output.

Any of the outputs can be used to drive LEDs, relays and the inputs of other electronic devices like
PLCs and counters. On OUT 1-4, the “+” (collector) and “-” (emitter) terminals of each transistor
are available at the connector. This allows you to configure each output for current sourcing or
sinking. Y1, Y2 and Y3 can only sink current. The YCOM terminal must be tied to power supply “-
”.

Diagrams of each type of connection follow.

Do not connect the outputs to more than 30VDC.
The current through each output terminal must not exceed 100 mA.

Sinking Output

BLU Servo

OUT-

OUT+

5-24 VDC

Power Supply

–

Load

INSIDE

9"2!+%

9#/-

9!,!2-

9).0/3.

INSIDE

SCREW

/54

This manual is related to the following products:

BLuDC9-Si