Applied Motion TXM24C-1CG - Manual (Page 18)

18
Rev. D
920-0088
TXM24C Hardware Manual
3.3.5 Programmable Output
The TXM24C drives feature three optically isolated digital output
(Y1,Y2,Y3). This output can be set to automatically control a motor
brake, to signal a fault condition, to indicate when the motor is in
position or to provide an output frequency proportional to motor speed
(tach signal). Or the output can be turned on and off by program
instructions like Set Output (SO). The output can be used to drive
LEDs, relays and the inputs of other electronic devices like PLCs and
counters. Y1, Y2 and Y3 can only sink current. The YCOM terminal
must be tied to power supply (-)
Diagrams of various connection types follow.
Do not connect the output to more than 30 volts. The current through the output terminal
must not exceed 100mA.
TXM24
Y1
YCOM
Y2
Y3
11
2
9
12
M12 I/O Connector
TXM24
YCOM
Y1/2/3
5-24 VDC
Power Supply
+ –
Load
Sinking Output Using Y1, Y2 or Y3
Sourcing Output Using Y1, Y2 or Y3
PLC
TXM24
5-24 VDC
Power Supply
+ –
YCOM
Y1/2/3
IN
COM
Driving a Relay Using Y1,Y2 or Y3
TXM24
YCOM
Y1/2/3
1N4935 suppression diode
5-24 VDC
Power Supply
+ –
relay