Applied Motion TSM17C-1CG - Manual (Page 21)

21
Rev. A
920-0085
TSM17C Hardware Manual
4 Troubleshooting
LED Error Codes
The TSM17C uses red and green LEDs to indicate status. When the motor is enabled, the green
LED flashes slowly. When the green LED is solid, the motor is disabled. Errors are indicated by
combinations of red and green flashes as shown below. This feature can be disabled for certain
warnings but not for alarms. See software manual for information on how to do this and which
warnings may be masked.
Code Error
Solid green no alarm,motor disabled
Flashing green no alarm,motor enabled
1 red,1 green motor stall (optional encoder only)
2
red,1 green ccw limit
2 red,2 green cw limit
3 red,1 green drive overheating
3 red,2 green internal voltage out of range
3 red,3 green blank Q segment
4 red,1 green power supply overvoltage or excess regen
4 red,2 green power supply undervoltage
4 red,3 green flash memory backup error
5 red,1 green Over current/short circuit
6 red,1 green Open motor winding
6 red,2 green bad encoder signal (optional encoder only)
7 red,1 green communication error
7 red,2 green flash memory error