ABUS Technologies Log Box-AA Data Logger - Manual (Page 6)

ABUS TECHNOLOGIES INC.
6
Log Box-AA
4. CONNECTIONS
Only the input connections and the External Battery Switch (when used) are
needed. The logger is exclusively powered by its internal battery. In the IP65 models,
the inputs and the signal for activating the external power supply are located inside the
logger case, which must be opened for accomplishing the connections. In the IP67
and IP68 models, proper connectors are provided for this purpose, as shown in Figure
IP67/IP68 connectors, below.
4.1 IP65 Model
Open the logger’s cover to get access to the block terminals and the configuration jumpers. Connection
cables must pass through the compress fitting located at the bottom of the case. Figure IP65
connections internal view, below shows the internal terminals distribution.
PARAMETER DESCRIPTION
Channel 1:
CN1 connector – Terminals
1, 2 and 3
Channel 2:
CN1 connector – Terminals
4, 5 and 6
External Battery
Switch
CN2 connector – Terminals
7, 8 and 9
Digital Input
CN2 connector – Terminals
7, 10 and 9
IP65 connections internal view
Note: Make sure that the compress fitting is perfectly tightening the cables, thus assuring proper IP65
protection: (totally dust-tight and protected against water jets).