Mac address filters, Filter settings, Add mac address – D-Link DGL-4300 User Manual

Page 39: Mac address list

Using the Conﬁguration Interface

D-Link Systems, Inc.

Mac Address Filters

The MAC (Media Access Controller) Address ﬁlter section is used to control network access based

on the MAC Address of the network adapter. A MAC address is a unique ID assigned by the

manufacturer of a networking device. This feature can be conﬁgured to ALLOW or DENY network/

Internet access.

Filter Settings

When this is enabled, depending on the mode selected, computers are

granted or denied network access based on their MAC address.

When Allow is selected, only computers with MAC addresses listed in the

MAC Address List are granted network access. When Deny is selected,

any computer with a MAC address listed in the MAC Address List

When this is selected, the MAC address ﬁlters will be applied to wireless

network clients.

When this is selected, the MAC address ﬁlters will be applied to wired

network clients.

Add MAC Address

MAC address entries are activated or deactivated with this checkbox.

Enter the MAC address of the desired computer or connect to the router from

the desired computer and click Copy Your PC’s MAC Address button.

Saves the new or modiﬁed MAC address in the MAC Address List. When

you are done editing the settings, you must click the Save Settings button

at the top of the page to make the changes effective and permanent.

MAC Address List

This section lists the current MAC address ﬁlters. Entries can be modiﬁed by clicking on the paper and

pencil icon. To delete an entry, click on the trash can icon. After you’ve completed all modiﬁcations

or deletions, you must click the

Save Settings button at the top of the page to save your changes.

The router must reboot before new settings will take effect. You will be prompted to

Reboot the

Device or Continue. If you need to make additional settings changes, click Continue. If you are

ﬁnished with your conﬁguration settings, click the

Reboot the Device button.

Enable MAC Address

Filter:

Mode:

Filter Wireless Clients:

Filter Wired Clients:

Enable:

MAC Address:

Save:

Advanced > MAC Address Filter