beautypg.com

Subaru 2006 B9 Tribeca User Manual

Page 212

background image

Interior equipment

6-15

CONTINUED

2. Press and hold the two outside

HomeLink® buttons until the indicator light

begins to flash (after 20 seconds). Re-

lease both buttons.

NOTE

If any of the HomeLink® buttons are al-

ready programmed for other devices,

skip step 2 because it clears the mem-

ory of all the three buttons.

3. Hold the end of the garage door open-

er’s hand-held transmitter between 1 and

3 inches (25 and 76 mm) away from the

HomeLink® buttons on the driver’s sun vi-

sor, keeping the indicator light in view.

4. Using both hands, simultaneously

push the hand-held transmitter button and

the desired HomeLink® button. DO NOT

release the buttons until step 5 has been

completed.

5. Hold down both buttons until the

HomeLink® indicator light flashes, first

slowly then rapidly. When the indicator

light flashes rapidly, both buttons may be

released. (The rapidly flashing light indi-

cates successful programming of the new

frequency signal.)

6. Press and hold the programmed button

and check the HomeLink® indicator light.

If the indicator light stays on continuously,

your garage door should activate and the

programming is completed.

If the indicator light flashes rapidly for two

seconds and then stays on continuously,

your garage door opener may be protect-

ed by a rolling code feature. In this case

you need to perform the additional steps

for “Programming rolling-code-protected

garage door openers in the U.S.A.” de-

scribed in the following.

NOTE

Rolling-code-protected garage door

openers are manufactured after 1996.

See the instruction manual of your ga-

rage opener for confirmation.

7. Reconnect the motor of your garage

door opener to the outlet.

8. Test your garage door opener by

pressing the programmed HomeLink®

button.

„

Programming rolling-code-

protected garage door open-

ers in the U.S.A.

If your garage door opener has a rolling

code feature, program the HomeLink®

Wireless Control System for it by following

steps 1 through 5 in the “Programming ga-

rage door openers in the U.S.A.” section

above and then continuing with the steps

below.

NOTE

The assistance of a second person

600430

600431

This manual is related to the following products: