beautypg.com

Subaru 2007 Legacy User Manual

Page 359

background image

Black plate (364,1)

北米Model "A2420BE-B" EDITED: 2006/ 7/ 26

11-16

Maintenance and service

Non-turbo models
1)

Fill up to here

Turbo models
1)

Fill up to here

5. Slowly pour the coolant and fill up to
just below the filler neck, allowing enough

room to add genuine Subaru cooling
system conditioner in the radiator. Add
genuine Subaru cooling system condi-
tioner until the coolant level reaches the
filler neck. Do not pour the coolant too
quickly, as this may lead to insufficient air
bleeding and trapped air in the system.

Coolant capacity (Guideline):

2.5-liter non-turbo models:

MT. 6.8 US qt (6.4 liters, 5.6 Imp qt)
AT. 6.7 US qt (6.3 liters, 5.5 Imp qt)

2.5-liter turbo models:

MT. 7.7 US qt (7.3 liters, 6.4 Imp qt)
AT. 7.6 US qt (7.2 liters, 6.3 Imp qt)

3.0-liter models:

7.6 US qt (7.2 liters, 6.3 Imp qt)

CAUTION

. Be careful not to spill engine

coolant when adding it. If coolant
touches the exhaust pipe, it may
cause a bad smell, smoke, and/or
a fire. If engine coolant gets on
the exhaust pipe, be sure to wipe
it off.

. Do not splash the engine coolant

over painted parts. The alcohol
contained in the engine coolant

may damage the paint surface.

6. Pour the coolant and fill to the reser-
voir tank

’s “FULL” level mark.

7. Put the radiator cap back on and
tighten firmly. At this time, make sure that