Subaru 2007 Legacy - Manual (Page 155)

Black plate (156,1)
北米Model "A2420BE-B" EDITED: 2006/ 7/ 26
3-34
Instruments and controls
Clock (Vehicle without Navi-
gation System)
NOTE
. If your vehicle is a non-turbo model
equipped with a navigation system,
refer to the separate
“Operating In-
structions for Monitor System ”.
. If your vehicle is a turbo model
equipped with a navigation system,
refer to the
“Clock (Vehicle with Navi-
gation System) ” in the multi-informa-
tion display (turbo models) section in
this chapter.
The clock shows the time while the
ignition switch is in the
“ACC” or “ON”
position.
To adjust the time shown by the clock,
press the
“+” button or the “−” button. The
indicated time will change in one-minute
increments. If you keep the button
pressed, the rate at which the indicated
time changes will speed up.
To reset the minutes to
“00” with a radio
time signal, push the “SET” button.
Information display (Non-tur-
bo models without Naviga-
tion System)
NOTE
If your vehicle is a non-turbo model
equipped with a navigation system,
refer to the separate
“Operating In-
structions for Monitor System ”.
With the ignition switch in the “ON”
position, each successive push of the
“DISP” button toggles the display in the
following sequence: