beautypg.com

Wireless remote control – TOYOTA 2011 Sienna User Manual

Page 408

background image

3

W
hen

troub

le
arise

s

59

3-1. When you think a malfunction has occurred

SIENNA AAS_U (OM45460U)

Wireless remote control

If the AUTO ACCESS SEAT does not move

Reason

Correction procedure

The wireless remote control is too far
away from the vehicle.

Move to within approximately 3.3 ft.
(1 m) of the AUTO ACCESS SEAT
and operate the wireless remote
control.

Electromagnetic waves in the sur-
rounding area may cause the wire-
less remote control to stop operating.

Change your standing position.

Operate the seat using the seat
raise/lower switch.

The battery of the wireless remote
control is discharged.

Replace the battery. (

→P. 40)

The switch is being pressed repeat-
edly.

Push and hold the switch.

The temperature of the surrounding
area may cause the wireless remote
control to stop operating.

Operate the seat using the seat
raise/lower switch.

If you suspect that the wireless remote control is malfunctioning, try

the correction procedures listed in the table below.

If the seat still does not operate even after trying the procedures, it is

likely that the wireless remote control is malfunctioning. Use the

seat raise/lower switch to operate the AUTO ACCESS SEAT (

P. 35),

and have the wireless remote control inspected by your Toyota

dealer immediately.

This manual is related to the following products: