Nexen TCD600E 912145 - Manual (Page 19)

FORM NO. L-20348-F-0705 19
Unwind Applications, Prox Encod Sensor
[Edit Job] (Parameters)
Full Roll: 060.00 in
Setpoint: 010.0 %
Hold Torque: 010.0 %
Stop Mult: 01.0X
Stp Time: 003.0 sec
Strt Time: 003.0 sec
Diam Hyst: 0.10 in
Min Dia Alrm: 006.00
Min Alrm: [NC] NO
Max Dia Alrm: 050.00
Max Alrm: [NC] NO
Accept Changes (Yes or No) Y [N]
CAL MODE
[Edit]
Diam Min Out Diam
Core Diam: 001.00 in
Max Diam: 060.00 in
Min Output: 000.0 %
SETUP MODE [Set Job]
[Save] Job 1 Job 2 Job 3 Job 4 Job 5
SETUP MODE [Set Job]
[Load] Default Job Job 1 Job 2 Job 3 Job 4 Job 5
Note: Refer to Glossary of Terms for explanations of the parameters.
QUICK REFERENCE SETUP AND CALIBRATION WORKSHEET
DEFAULT JOB 1 JOB 2 JOB 3 JOB 4 JOB 5