Nexen RSD200 Communications Kit 964527 User Manual
Web control products, Rsd200 c, Ommunications

form no. l-21695-A-1105
1
W
2
2
RSD200 C
ommuniCationS
S
oftwaRe
i
nStRuCtionS
The communications software is used to setup, tune and diagnose the rSD200 Dancer Controllers.
ComPUTEr rEQUIrEmEnTS
microsoft
®
Windows
®
98 (or newer) or compatible operat-
ing system and available 9-pin male serial port.
SOFTWARE INSTALLATION BY INTERNET
1. rSD200 Communications Software is available for download
from the nexen web site at www.nexengroup.com
2. navigate to the RSD200 Communications Software (P/n
964527) product page.
3. Click on the appropriate software product and select Download
Software under resources.
4. At the open/Save prompt, select Open. The software
will be downloaded and the installation process will start
automatically.
5. follow the directions for Installation.
SOFTWARE INSTALLATION BY CD
1. Insert the disk into the computer's CD drive.
2. The installation should start automatically.
If not, select rUn from the Windows STArT menu. Click on
BroWSE and locate the CD drive in the directory. Select
"setup.exe" and click oK at the rUn pop-up window.
3. follow the directions for Installation.
SOFTWARE OPERATION
1. Connect the communications cable to an available 9-pin male
serial port on the computer.
CAUTION
Electrostatic discharge can damage the circuit board.
Avoid excessive handling and, if possible, wear an
antistatic wrist strap.
2. Carefully remove the cover of the rSD to gain access to the
circuit board.
3. Set jumper W2 to position 1 (See figure 1).
4. Connect the other end of the communications cable to the
rSD circuit board connector (as shown)
5. Apply power to the rSD200.
6. Click on the
RSD200 Comm icon located on the desktop.
7. Click on the Help menu and select Help.
8. read the help files for instruction on using the rSD200
Communications Software.
Serial
Port
Programming
Cable
Connector
Circuit
Board
WEB CONTROL ProDUCTS
User manual
FIGURE 1
NOTE
The rSD200 must be powered up in order to
open the communications line with the rSD200
Communications Software