Nexen TL60-A 951243 - Manual (Page 15)

15 FORM NO. L-20138-U-0912
FIGURE 18
19
21
21
5
DRIVE FLANGE BALL BEARINGS
1. Remove the Retaining Ring (Item 5) from the Drive
Flange (Item 19) (See Figure 18).
NOTE: The Drive Flange Assembly consists of:
machine screws, ball seat, balls, and Drive Flange. If
any of these items show signs of wear or damage,
the entire Drive Flange Assembly (Item 19) must be
replaced.
2. Fully support the Drive Flange Assembly (Item 19)
and press the Ball Bearings (Item 21) out of Drive
Flange Assembly (See Figure 18).
NOTE: Do not reuse old Ball Bearings. Applying force
to the inner race to remove ball bearings held by the
outer race causes damage to ball bearings.
3. Clean the bearing bore of the Drive Flange
Assembly (Item 19) with fresh solvent, making sure
all old Loctite
® residue is removed.
4. Apply an adequate amount of Loctite ® 680 to evenly
coat the outer race of the new Ball Bearings (Item
21) and press the new Ball Bearings into the Drive
Flange Assembly (Item 19) (See Figure 18).
5. Reinstall Retaining Ring (Item 5) (See Figure 18).
WARNING
Special attention should be exercised
when working with retaining rings.
Always wear safety goggles when
working with spring or tension loaded
fasteners or devices.