Nexen TL60-A 951243 - Manual (Page 11)

11 FORM NO. L-20138-U-0912
R
e
-S
etting
P
RoceduRe
1. Shut down the machine drive.
2. Apply air pressure to the Torque Limiter.
3. Rotate Drive Flange Assembly by hand or in "jog"
mode until the balls are engaged in the detents.
4. Restart the machine drive.
i
nteRface
d
eSign
The Torque Limiter interface consists of five opposing balls and detents that are not equally spaced and engage in one
rotational position. This feature provides exact timing or registry of machine components connected on the drive and
driven side of the Torque Limiter. If an overload occurs, the torque limiter interfaces separate to completely disconnect
drive components from driven components.
OPERATION
TABLE 7
L E D O M S D E E P S G N I T A R E P O M U M I X A M
C A - 0 2 L T , A - 0 2 L T M P R 0 0 8 1
C A - 0 3 L T , A - 0 3 L T M P R 0 5 6 1
C A - 0 4 L T , A - 0 4 L T M P R 0 5 3 1
C A - 0 5 L T , A - 0 5 L T M P R 0 0 2 1
C A - 0 6 L T , A - 0 6 L T M P R 0 5 0 1
C A - 0 7 L T , A - 0 7 L T M P R 0 5 9
C A - 0 8 L T , A - 0 8 L T M P R 0 0 8
NOTE: Machine must come to a complete stop
before Torque Limiter can be reengaged. Torque
Limiter may run in excess of 200 o F [93°C] as
measured on the Air Chamber until Rotary Seal has
worn in.
WARNING
Never exceed maximum operating speeds listed for your product. (See Table 7).
CAUTION
The balls will not find the detents without
sufficient resistance of the drive flange
downstream to prevent it from rotating.
CAUTION
The temperature limits for the TL
product line are 4.5-100 Degree
Celsius (40-220 Degree F).