WebDT DT390/ DT390i Modules BOG (XPE/ XPPro) - Manual (Page 6)

WebDT Mobile Tablet Barcode Scanner Operation Guide
HyperTerminal
www.dtresearch.com HyperTerminal
HyperTerminal
The HyperTerminal can be used to connect the Barcode Scanner and MSR.
1. Run Start l All Programs l Accessories l Communications l HyperTerminal to run the
HyperTerminal.
2. Input a connection name in “Connection Description” window.
3. Choose the connection port (please refer to the parameters table
of each module), then click OK.
4. Change the port Properties (please refer to the parameters table
of each module), then click Apply to complete the settings.
5. If the settings are all correct, HyperTerminal will be connected to
the module. Scan a barcode or swipe a card, the captured data
will display in the HyperTerminal window.
6. Verify the captured data.
WebDT 390/ 390i OPERATION GUIDE