beautypg.com

WebDT DT391UF User Manual

Page 2

background image

DT391UF

Button Functions

BUTTON

ACTION

Push/release typically enters Standby mode, or Push/release exits Standby mode or

restarts tablet (software dependent)
Push and hold (over 4 seconds) invokes hardware shutdown

Input/ Output Ports

USB Port

USB Port

Headphone Jack

DC Power Input

Micro SD Slot (inside)

External GNSS Antenna Interface

The DT391UF

1

A

B

C

D

E

F

ENGLISH

2

3

ENGLISH

Power/Battery LED Status:

Blue indicates the battery is 25% to 100% charged

Blinking blue indicates the battery is charging

Orange indicates that the battery is between 11% to 25%

Blinking Orange indicates that the battery is below 10%

Precautions

Always exercise care when operating and handling the DT391UF.

Do NOT apply excessive pressure to the display screen.

Avoid prolonged exposure of the display panel to any strong heat source. Wherever

possible, the DT391UF should face away from direct light to reduce glare.

B

• e careful while adjusting the antenna

If the AC-DC power adapter is used to recharge or power the tablet, do NOT use any

AC-DC adapter other than the one provided or acquired from the manufacturer or its
partners.

In the unlikely event that smoke, abnormal noise, or strange odor is present,

immediately power off the DT391UF and disconnect all power sources. Report the
problem to your device provider immediately.

Never attempt to disassemble the

DT391UF, as this will void the warranty.

THE DT391UF

Basic Features

The DT391UF wireless tablet integrates a bright display, two USB ports, and embedded
networking elements such as wireless LAN and Bluetooth or optional 3G. The DT391UF
is complemented by a suite of accessories, including battery expansion, charging cradles,
and battery charger kit, for a comprehensive user experience.

A DT391UF typically integrates an 802.11ac wireless LAN (WLAN) adapter that may
connect to other wireless devices or access points. If your DT391UF does not come with
a network adapter, please consult your device provider to establish the desired network
connectivity.

Wireless LED

Camera (optional)

Foldable Antenna for the

UHF RFID Reader

Battery/Power LED

1

C

E

B

A

D

F