Vortech 1996-2004 Ford 4.6 Mustang GT - Manual (Page 36)

P/N: 4FL020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
14APR08 v3.0 MusGT Bull(4FLv3.0)
Fig. 12-a
Fig. 12-c Fig. 12-b
*A. Separate the passenger side ignition coil
from the factory bracket previously
removed from the front engine cover.
*B. Remove the two bolts located at the front/
top corner of the passenger side valve
cover.
*C. Install the Vortech supplied coil bracket
onto the valve cover reusing the factory
bolts to secure.
*D. Attach the coil to the new bracket using the
supplied #10 hardware. Orient the assembly
following the graphic (see Figs. 12-b, 12-c),
reattach all plug wires and reconnect the
factory harness.
**E. Relocate the ignition capacitor to the
passenger side alternator mounting bolt.
The paint may need to be scraped away to
ensure proper grounding. (See Fig. 12-a.)
A. Remove the plastic tube connecting the
throttle body to the passenger’s side valve
cover. Remove the foam insulation cover
from the tube and discard.
B. Trim 4" off of the end of the plastic tube
that connected previously to the
passenger’s side valve cover.
C. Replace the factory PCV valve with the
supplied PCV valve.
D. Trim the 3/8" hose line to 2" in length and
install onto the supplied PCV valve.
Connect the open hose end to the supplied
reducer barb. Trim the supplied 5/8" hose
to the factory plastic tube. (See Fig. 13-a .)
E. Reconnect the PCV tube to the throttle
body.
13. PCV ASSEMBLY, (2003-2004 MODELS ONLY)
Fig. 13-a
* '96-'98 models only
** '99-'04 GT/01 Bullitt models
12. IGNITION RELOCATION
1999-2004 Models Only
1996-1998 Models Only
RELOCATED
CAPACITOR
CONNECTS TO PASSENGER’S
SIDE VALVE COVER
FRONT FRONT
COIL BRACKET MOUNTING LOCATION
CONNECTS TO THROTTLE BODY
P/N: 4FL020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
14APR08 v3.0 MusGT Bull(4FLv3.0)
25