Vortech 1996-2004 Ford 4.6 Mustang GT - Manual (Page 27)

F. Using the supplied 3/8-16 x 1.75" bolts and
3/8" AN washers, secure the supercharger
to the Vortech aluminum mounting bracket,
except where indicated. (See Fig. 8.2-c.)
G. Using the supplied 3/8-16 x 2" bolt, fasten
the Vortech idler mounting plate to the
supercharger and mounting bracket. Do not
use a washer. Align the second hole while
torquing the bolt. Secure the factory
smooth idler to the idler mounting plate
with the supplied 12mm x 25mm bolt and
dust shield. Use thread locking compound.
Make sure the “open” side of the pulley is
installed toward the alternator.
**H. Detach the wiring harness support bracket
from the harness. Enlarge the hole on the
bracket using a 27/64" drill bit. (See Fig. 8.
2-d.) Remove any sharp edges around the
enlarged hole and reinstall it onto the
harness. (Failure to re-install this bracket
between the Vortech bracket and front
cover will result in bracket misalignment
and possible parts failure.)
Fig. 8.2-b/ Upper Idler
Fig. 8.2-c
8.2 MAIN BRACkET ASSEMBLY (2000-2004 MODELS ONLY), CONT’D.
FILE THE EDGES OF
EACH BOSS DOWN IF
REQUIRED FOR IDLER
CLEARANCE
** 2000 Models Only
12mm x 25mm Bolt
Dust Shield
Temporarily insert
an 8mm bolt lightly into
this hole to ensure
proper alignment
Supplied
composite idler
(smooth)
3/8”-16 x 2” Bolt
(no washer)
(5) 3/8-16 x 1.75”
Bolt and Washer
P/N: 4FL020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
12APR08 v3.0 MusGT Bull(4FLv3.0)
16