Vortech 1996-2004 Ford 4.6 Mustang GT User Manual

Page 16

P/N: 4FL020-010

14APR08 v3.0 MusGT Bull(4FLv3.0)

Remove the spare tire, etc. from the trunk.

Trim “cut-out” from the template provided in the

kit and place over spare tire hold-down.

Centerpunch and drill the four 3/16" holes in the

trunk floor.

Jack up the rear of the car and support with jack

stands.

Mount the T-Rex fuel pump to the underside of

the tire well with the rubber mounts, adel clamps

and fasteners provided. Refer to the graphic on

the following page.

Remove the female hose end connected to the

fuel filter inlet.

Insert the T-Rex inlet hose assembly into the

female supply hose fitting by gently pushing the

fittings together and making sure they are locked.

Fasten the extended feed line clear of the filter by

looping the two 11" cable-ties through the front

slot on the fuel filter mount, being careful not to

kink the line.

Plug the female connector located on the T-Rex

discharge line onto the fuel filter inlet making sure

the hose assembly clears all exhaust tubing and

sharp objects.

Position the reflective sleeve on the pump

discharge line so that it receives maximum

protection from the tailpipe.

Mark and drill a 1/8" hole and mount the relay

inside the trunk in position as shown in the

template. Use the sheet metal screw provided.

From relay terminal #85, tap the yellow wire into

the stock fuel pump harness in the trunk near the

right tail light. Tap into the purple wire with the

supplied scotch lock. (On some model years, the

wire may be brownish-green.)

Connect the short red wire on relay terminal #8 to

the (+) terminal on the fuel pump.

Connect the longer black wire from the (-) terminal

on the fuel pump to a clean ground.

Connect the short black wire to a clean ground

from relay terminal #86 (relay screw mount works

well).

Route the remaining long red wire from relay

terminal #30 up to the fuse panel located under

the dash. Using a solderless connector, connect

the supplied fuse holder and fuse to the end of

the wire. Crimp the fuse wire to the supplied

female slide and fuse tap. Attach fuse tap and

wire to fuse #17.

5.1 FUEL PUMP INSTALLATION (1996-1997 MODELS ONLY)

NOTE: Use extreme caution when routing fuel

lines. Make sure fuel lines are located

away from hot exhaust pipes and sharp

edges on vehicle underbody.

P/N: 4FL020-010

14APR08 v3.0 MusGT Bull(4FLv3.0)