Step 2: set up wiconnect system transmitter, Setup wi-q user’s manual, Lfe/sub connection – Velodyne Wi-Q User Manual
Page 9: Channel selector
9
Setup
Wi-Q User’s Manual
Step 2: Set Up WiConnect System Transmitter
Note:
The Wi-Q transmitter model is the
WiConnect System Transmitter
. The Wi-Q subwoofer
must be within 50 feet (15 meters) of the transmitter to be able to receive the wireless signal. Also,
make sure that the same CHANNEL is selected on both the transmitter and the subwoofer.
1.
Do one of the following to connect the transmitter to your audio receiver.
• For Audio Receivers with LFE/SUB Output (most common):
This setup requires one RCA
cable. Plug one end of the RCA cable into the
LFE input
on the transmitter and plug the other
end into the
LFE
or
SUB output
on your audio receiver.
• For Audio Receivers or Zones without LFE/SUB Output or Connection (less common):
This setup uses one stereo RCA cable. Plug one channel of the RCA cable into the
R input
on
the transmitter and the
R output
on your audio receiver. Plug the other channel of the RCA cable
into the
L input
on the transmitter and the
L output
on your audio receiver.
Figure 3: Transmitter connections
2.
Plug the power adapter into the back of the transmitter. Plug
the other end of the adapter into a power outlet.
3.
Make sure the CHANNEL setting on the transmitter matches
the CHANNEL setting on the back of the subwoofer. For
example, choose CHANNEL 2 in both places. You have four
channels to choose from.
Figure 4: Channel selections
LFE
Front
Center
Surround
L
R
L
R
Front
+
-
+
-
12v
Trigger
L
R
LFE
TX
INPUT
1 2 3 4
CHANNEL
DC IN
+
-
LFE/SUB connection
L
R
LFE
TX
INPUT
1 2 3 4
CHANNEL
DC IN
+
-
LFE
Front
Center
Surround
L
R
L
R
Front
+
-
+
-
12v
Trigger
Left/Right connection (without LFE/SUB)
Power
adaptor jack
Power
adaptor
jack
L
R
LFE
TX
INPUT
1 2 3 4
CHANNEL
DC IN
+
-
Channel selector