Taser Axon-Flex - Manual (Page 6)

6 | P a g e
2.d Select the retention duration unit from the drop-down list and enter the desired
retention period.
2.e Click Save Category.
Task C – Establish Security Settings
1. On EVIDENCE.com, from the Settings menu, select Security Settings, and then select
Security Settings.
2. If desired, enable IP security:
2.a Select Single IP Address or Range of IP Addresses.
2.b Enter IP Address or IP address range to be allowed access.
2.c Enter an optional label for the IP address or address range.
2.d Click Add Allowed IP Address.
2.e Repeat steps 2.a–2.d for all desired IP addresses.
2.f Click the Enable IP Security check box.*
3. If desired, enable dual factor authentication.
3.a Select the desired authentication protocol.
3.b Enter desired verification code duration (maximum 60 minutes).
3.c Click Save.
3.d Select the Enable Dual Factor Authentication check box.**
*Once IP security is enabled, computers with unapproved IP addresses will be unable to log into your agency account on EVIDENCE.com, even if
they have correct username and password combinations.
**When dual factor authentication is enabled, every time a user signs in to their account, a verification code will be sent to them that they
must enter before being granted access to their account.
Task D – Establish Password Settings
1. On EVIDENCE.com, from the Settings menu, select Security Settings, and then select
Password Configuration.
2. If desired, adjust the settings.
3. After adjusting the settings, click Save for the new settings to be applied.
Task E – Establish Agency Camera Settings
1. On EVIDENCE.com, from the Settings menu, select Configuration Settings, and then
select TASER Video Settings.