Taser Axon-Body - Manual

Step 2:
Camera Operation LED
The AXON body camera’s operation LED displays the system’s current operating
mode.
Operating Mode Operation LED
Recording Blinking red
Buffering Blinking green
Booting up/powering down Solid red
Step 3:
Battery LED
The camera’s battery LED displays the battery’s remaining capacity, when the device
is being used or when charging.
Battery Status Battery LED
Battery capacity is 41–100% Green
Battery capacity is 20–40% Yellow
Battery capacity is less than 20%
Red during operation; flashing red and
yellow during charging
Battery critically low Blinking red and yellow
TASER AXON body Quick Start Guide
English (U.S./Canada/Australia/U.K.)
Hardware
AXON body USB Cable
AXON body Camera
AXON body Wall Charger
Quick Reference
Audio quality will be reduced if the camera is not in the holster.
Bluetooth Pairing and Upload
Status LED
Bottom View
Volume/Pairing
Battery Status Button
Push to Show Status of
Battery
Camera Lens
Speaker
Battery LED
Green = 41% - 100%
Yellow = 20% - 40%
Red = Less Than 20%
Microphone
Power Switch
Red = On/Buffering
Event Button
Double Tap = Start Record
Hold 3 Sec = Stop Record
Recharging/Dataport
Data Transfer & Recharging
through PC or EVIDENCE.com
Dock
Top View
Operation LED
Step 1:
Recording
The AXON body camera has two operating modes. The default mode, or BUFFERING
mode, provides pre-event buffering to capture activities that occur before you
activate the EVENT (recording) mode.
1 Turn the system on. Move the ON/OFF switch to the ON position.
Solid Red
Boot Up Mode
Blinking Green
Buffering Mode
• The camera takes a few seconds to boot up and be ready to record (the red area
under the switch will be exposed with the switch moved to the ON position).
• The operation LED will be solid red and then transition to blinking green
when the system goes into BUFFERING mode.
• The AXON body camera will go into BUFFERING mode after the boot up
sequence. The BUFFERING mode holds the previous 30 seconds of video
[NO AUDIO] leading up to the beginning of a recording.
2 To record, quickly double-press the EVENT button.
• The camera now records audio as well as video.
• The camera will beep twice to let you know that recording has started. The
2 beeps will repeat every 2 minutes (if the system is muted, there will be
no audio notifications).
• The operation LED will blink red.
Event Button Blinking Red - Record Mode
3 To stop recording and return to BUFFERING mode, press and hold the EVENT
button for at least 3 seconds until there is a long, audible beep.
Because the system does not capture audio in BUFFERING mode, the first 30
seconds of a recorded event will be video-only (depending on your agency’s
settings). BUFFERING mode starts only after the camera is turned on. The system
does not record when the AXON body camera is turned off.